FORD explorer - Manual (Page 85)

Displaying the Factory Set Code
With Integrated Keyhead Transmitters
Note: You will need to have two programmed passive anti-theft keys for
this procedure.
To display the factory-set code in the information display:
1. Insert a key into the ignition and switch the ignition on for a few
seconds.
2. Switch the ignition off and remove the key.
3. Insert the second key into the ignition and switch the ignition on.
The factory-set code will display for a few seconds.
Note: The code may not display until after any other warning messages
first display.
With Intelligent Access Keys
Note: You will need to have two programmed intelligent access keys for
this procedure.
To display the factory-set code in the information display:
1. Place the first programmed key
in the backup slot inside the center
console. The key ring must be at
the top with the buttons facing
toward the rear.
2. Press the START/STOP button
once and wait a few seconds.
3. Press the START/STOP button
again and remove the key.
4. Insert the second programmed key into the backup slot, then press
the START/STOP button.
The factory-set code will appear in the information display for a few
seconds.
Note: The code may not display until after any other warning messages
first display.
84 Locks
2014 Explorer (exp)
Owners Guide gf, 1st Printing, April 2013
USA (fus)