John Deere z425 - Manual (Page 9)

Assembly - 8
ASSEMBLY
Install Deck Height Pin
MX37775
1. Be sure mower is fully raised to the transport lock position, as shown,
and insert the pin (A) in the hole just below the mower deck lift lever (B).
Install Seat
1. Remove and discard four bolts and wood block holding seat onto foot
plate.
MX38092
2. Raise seat platform (A), and install seat (B) onto platform. Secure with
washers and bolts (C).
3. Route harness connector (D) up and onto seat switch, and secure
harness plug (E) into hole in seat platform.
4. Lower seat.
Check Tire Pressure
Check tire pressure. (See Checking Tire Pressure in the SERVICE
MISCELLANEOUS section.)
Adjust Mower Deck Level
Adjust mower deck level. (See Adjusting Mower Deck Level in the
OPERATING section.)
Check Engine Oil Level
Check engine oil level. (See Checking Engine Oil Level in the SERVICE
ENGINE section.)
Check Machine Safety System
Perform safety system check to make sure the electronic safety interlock
circuit is functioning properly. Perform all tests. (See Testing Safety
System in the OPERATING section.)
A
B
B
C
C
D
E
A