John Deere 318 User Manual

Page 251

Advertising
background image

ASSEMBLE MOWER GEAR CASE—LATER
60-INCH MOWER (PEERLESS)

IMPORTANT: Always use new seals and O-rings.

Damaged or used parts will leak.

NOTE: Lubricate all O-rings with petroleum jelly during

assembly.

Apply clean gear case oil on all internal parts
during assembly.

1. Install snap ring (G) in first groove under keyway for
key (H).

2. Install key (H), bevel gear (F) and shims (E). Install
bevel gear on shaft with shoulder facing away from snap
ring (G).

3. Press bearing cone (D) on output shaft (C) with small
O.D. facing away from shims (E). Install bearing cone
until it bottoms against shims.

4. Install snap ring (B).

5. Press bearing cone (A) on output shaft with small
O.D. facing away from bevel gear (F). Install bearing

Output Shaft Assembly

until it bottoms against snap ring.

A—Bearing Cone
B—Snap Ring
C—Output Shaft
D—Bearing Cone
E—Shims (as required)
F—Bevel Gear
G—Snap Ring
H—Key

M77315

-UN

-24FEB95

MX,15908015,24 -19-13MAR95

Mower Gear Case Repair/Later 60-Inch Mower (Peerless)

TM1590 (17MAY95)

80-15-23

316, 318 & 420 Lawn and Garden Tractors

020895

80

15

23

Advertising
This manual is related to the following products:

316, 420