Configure network settings, View or change network settings – HP Laserjet p1606dn User Manual
Page 41
HP Smart Install on a wired network
NOTE:
This installation type is supported for Windows only.
1.
Print a configuration page and locate the product IP address. See
2.
Open a Web browser using the computer where you want to install the product.
3.
Type the IP address for the product in the address line of the browser.
4.
Click the HP Smart Install tab.
5.
Click the Download button.
6.
Follow the onscreen instructions to complete the product installation.
CD installation on a wired network
NOTE:
When you use the CD to install the software, you can select the Easy Install (recommended) or
the Advanced Install (you are prompted to accept or make changes to defaults) installation type.
1.
Insert the software installation CD into the computer CD drive.
2.
If the installation program does not open automatically, browse the CD contents and run the
SETUP.EXE file.
3.
Follow the onscreen instructions for setting up the product and installing the software.
NOTE:
Make sure that you select Configure to print over the Network when prompted.
Configure network settings
View or change network settings
Use the embedded Web server to view or change IP configuration settings.
1.
Print a configuration page, and locate the IP address.
●
If you are using IPv4, the IP address contains only digits. It has this format:
xxx.xxx.xxx.xxx
●
If you are using IPv6, the IP address is a hexadecimal combination of characters and digits. It
has a format similar to this:
xxxx::xxxx:xxxx:xxxx:xxxx
2.
To open the embedded Web server, type the IP address into the address line of a Web browser.
3.
Click the Networking tab to obtain network information. You can change settings as needed.
ENWW
Connect to a network
29