GE nautilus dishwasher User Manual

Page 21

Advertising
background image

Customer Service

Troubleshooting T

ips

Operating Instructions

Safety Information

21

Problem

Possible Causes

What To Do

Water won’t pump

Drain is clogged

If you have an air gap,

out of the tub

clean it.

Check to see if your kitchen

sink is draining well. If not,

you may need a plumber.

If the dishwasher drains into a

disposer, run disposer clear.

Suds in the tub

Correct detergent

Use only automatic dishwasher

wasn’t used

detergents to avoid sudsing.

Cascade® Automatic

Dishwashing Detergent has

been approved for use in all

GE dishwashers.

To remove suds from the tub,

open the dishwasher and let

suds evaporate. Add 1 gallon

of cold water to the tub. Close

the door until it locks into

place. Pump out water by

pressing

START/RESET,

then

immediately press

START/RESET

again. Repeat if necessary.

Rinse agent

Always wipe up rinse agent

was spilled

spills immediately.

Stained tub interior

Detergent with

Some detergents contain

colorant was used

colorant (pigment or dyes)

that will discolor the tub

interior with extended use.

Check the detergent cup

for signs of any discoloration.

If cup is discolored, change to

detergent without any colorant.

Cascade® Automatic

Dishwashing Detergent has

been approved for use in all

GE dishwashers.

Some tomato-based

Use of the

RINSE ONLY

cycle

foods can stain

(on some models) after adding

the dish to the load can

decrease the level of staining.

Advertising