GE nautilus dishwasher - Manual (Page 24)

Safety Information
Operating Instructions
Troubleshooting T
ips
Customer Service
24
Before you call for service…
Troubleshooting Tips
Problem Possible Causes What To Do
Dishes don’t dry Low inlet water • Make sure inlet water
temperature temperature is correct
(see page 12).
• Select HI TEMP RINSE
and/or HEATED DRY.
Rinse agent dispenser • Check the rinse agent
is empty dispenser.
Control panel Door latch may not be • Call for service.
responded to inputs properly seated
but dishwasher never
filled with water
Dishwasher won’t run Fuse is blown, or the • Replace fuse or reset
circuit breaker tripped circuit breaker. Remove
any other appliances from
the circuit.
• Try resetting the
START/RESET pad.
Steam This is normal • Steam comes through
the vent by the door latch
during drying and when
water is being pumped out.
Sanitized light does The door was opened • Do not interrupt the cycle
not illuminate at the and the cycle was anytime during or after
end of the cycle interrupted during or main wash.
after the main wash
portion
The incoming water • Raise the water heater
temperature was too low temperature to 120°F.