Edge Lighting Plaza Large Dimmable User Manual

Plaza large, Install the mounting plate, Installation instructions for

Advertising
background image

G

N

L

G

N

L

G

N

L

G

N

L

Installation Instructions for

Plaza Large

904-PLAZA-L-F1D-05

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

Install the Mounting Plate

1

PLAZA-L-F1-_

© 2012 Edge Lighting. All Rights Reserved.

A

1: Loosen and remove the four M6 screws on the top and
bottom of the mounting plate with the 3mm Allen wrench.

2: Pull the mounting plate completely out of the mirror.

SAVE THESE INSTRUCTIONS!

- This product is ETL listed for indoor dry locations.
- This product is wall mounted only.
- Supply power to mirror in accordance with local electrical
codes.
- This instruction shows a typical installation
- This product is dimmable with 0-10V dimmers.

IMPORTANT INFORMATION

NOTE:

It is recommended that one person holds the mounting

plate while the electrician installs it.

B

M6 SCREW

3MM ALLEN
WRENCH

MIRROR

MOUNTING PLATE

1

1

1

1

2

3

PLAZA-L-F1D-_

MOUNTING PLATE
CENTER HOLE

3

3: Align the mounting plate hole with the power line conduit, or
electrical box, and use the mounting plate as a template to
mark four mounting holes onto the wall.

NOTE:

Make sure that the mounting plate is leveled

horizontally.

4: Use a 9/32 drill bit to make holes on all six marked points.

5: Tap the anchors into the drilled holes with a hammer.

C

WALL

4

ANCHOR

9/32
DRILL BIT

5

5

Advertising
Table of contents