Edge Lighting LED Touch Sensor Switch - Manual

SEN-IR-OC
Installation Instructions for Soft Strip LED Sensor Switch
904-SEN-IR-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2012 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
IMPORTANT INFORMATION
SEN-IR-SW
SEN-LTS-SW
Install the Sensor Switch
1: Loosen the Phillips screws on top of the sensor switch box to
remove the cover exposing the terminal blocks.
2: Secure the sensor switch box to the desired location with
the two screws.
A
B
3: Refer to the wiring diagram below, connect the hot & neutral
power line to the L & N input 120 terminals.
4: Connect the hot & neutral power supply wires to the L & N
output terminal.
5: Replace the sensor switch box cover and secure it by
tightening the Phillips screw.
INPUT
120-240VAC
OUTPUT
120-240VAC
L
N
N
L
SENSOR SWITCH
SENSOR
POWER SUPPLY
OUTPUT
24VDC
INPUT
120VAC
LINE NEUTRAL
LINE
NEUTRAL
1
General Wiring Diagram
COVER
WIRE
TERMINAL
BLOCK
PHILLIPS
SCREW
SENSOR SWITCH BOX
TERMINAL BLOCK
120VAC POWER
WIRES
1
3
5
6: Install sensor within 3 feet of the sensor switch.
Test Prior installation.
7: Depending on model use either double sided tape or make a
7/16" hole to secure the sensor in place.
8: Connect the sensor wires to the sensor box.
WITHIN
3FEET
2
2
SENSOR
DOUBLE
SIDED TAPE
C
SENSOR
KNURLED
NUT
PANEL
7
7
SENSOR SWITCH BOX
4
SENSOR
SENSOR
SWITCH BOX
8