Edge Lighting Puck LED - Manual

Installation Instructions for Puck LED
904-PUCK-04
Recessed Mount Installation
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2012 Edge Lighting. All Rights Reserved.
1: Remove the mounting ring and discard it.
2: Mark the location where the LED Puck light is going to be
recessed.
3: Drill out the marked location with a 2.5" circular saw.
4: Feed the LED Puck light wires through the cut out hole and
snap the LED Puck light into the hole.
5: Repeat the steps 1 through 4 for the remaining pucks and
then follow the "Power the Puck Lights" steps.
A
PUCK-RD-3W-90D-30K-SA
1
SAVE THESE INSTRUCTIONS!
- This product can be installed as recessed or surface
mount.
- It is recommended to use the HUB-4P or HUB-8P to power
the Puck Lights.
- This product works with a 12 Volt AC LED electronic
transformer (TE-60L-12) & is dimmable with a low voltage
electronic dimmer.
- This installation instruction shows typical installation.
IMPORTANT INFORMATION
SURFACE
2.5"
(6.35cm)
4
3
Surface Mount Installation
SURFACE
B
NOTCH
NOTE: Omit the steps below if surface mounting the Puck Lights.
1: Remove the mounting ring.
2: Use the mounting ring as a template to mark the screw
location where the LED Puck light is going to be installed.
3: Use a 1/16" drill bit to drill pilot holes on marked locations.
4: Feed the LED Puck wires through the mounting ring. Hold
the cord against the notch on the mounting ring while
installing the mounting ring to the pilot holes with the
provided two Phillips screws.
5: Pull the cord through the notch on the mounting clip and
snap the LED puck light into the mounting ring.
6: Repeat the steps 1 through 5 for the remaining pucks and
then follow the "Power the Puck Lights" steps.
MOUNTING
RING
LED PUCK
5
FIXTURE
1
MOUNTING
RING
FIXTURE
1
4
4
PHILLIPS
SCREW
5
6
LED PUCK