Canon eos rebel g - Manual (Page 58)

Troubleshooting Guide
— _ _ _■ 11 »' iwwf
1
■ ' ■ m >i i
If there is a problem, first refer to this Troubleshooting Guide. If the
problem still persists, take your camera to your nearest Canon Service
Center. Canon Service Centers are listed on the back of this booklet.
Problem Probable Cause Solution , • 3 age No.
1. Nothing is
displayed
The batteries are exhausted, Replace the batteries with new
ones.
10
on the LCD
panel,
The batteries have been installed
incorrectly.
Install the batteries correctly.
10
2. The shutter
does not
release.
The film has not been loaded
correctly, (The frame No. is not
displayed on the LCD panel.)
Load the film correctly.
14
Rewound film is still in the camera.
(The frame counter on the LCD
panel is blank.) Take out the film cartridge and load
a new roll of film. 14
Focus has not been achieved. (The
in-focus indicator in the viewfinder
is blinking.)
Press the shutter button halfway
until focus is achieved. If focus still
cannot be achieved, set the focus
mode switch on the lens to MF (or
M on some lenses) and focus
manually with the focusing ring,
12
3. The
photograph
is out ol
focus.
The focus mode switch on the lens
was set to MF (or M on some
lenses) (Manual Focus).
Set the focus mode switch on the
lens to AF (Autofocus). 12
[ The shutter speed was too slow to
prevent blur caused by camera
shake.
Press the shutter button without
shaking the camera or use a faster
shutter speed.
13
4. Only q
blinks or
appears on
the LCD
panel.
The battery level is very low. Replace the batteries with new
ones and check that the battery
level is displayed on the LCD panel.
11
The camera is not operating
properly.
Press the shutter button halfway to
return the camera to normal.
* If o is still displayed even after
the above solutions are
executed repeatedly, the
camera needs repair, Take it to
the nearest Canon Service
Center.
11
Back
cover
58