FORD 2013 E-450 v.1 - Manual (Page 32)

Perform the following steps to install a child safety seat with tether anchors:
Front passenger seating position
The tether can be attached directly
to the rear of the front seat.
1. Adjust the front passenger seat fully forward.
2. Route the child safety seat tether
strap over the back of the front
right-hand passenger seat as shown.
3. Clip the tether strap hook to the
seat pedestal at the location shown.
If the tether strap is clipped
incorrectly, the child safety seat
may not be retained properly in the
event of a collision.
4. Adjust the front passenger seat to the full rearward position.
5. Tighten the child safety seat tether strap according to the
manufacturer’s instructions.
If the safety seat is not anchored properly, the risk of a child being
injured in a collision greatly increases.
32 Child Safety
2013 Econoline (eco)
Owners Guide gf, 1st Printing
USA (fus)