Tpms reset procedure, Overview, Performing the tpms reset procedure – FORD 2012 F-150 Raptor v.3 User Manual

Page 259: Tires, wheels and loading

Advertising
background image

TPMS Reset Procedure

WARNING: To determine the required pressure(s) for your
vehicle, refer to the Safety Compliance Certification Label

(affixed to either the door hinge pillar, door-latch post, or the door
edge that meets the door-latch post, next to the driver’s seating
position), or Tire Label located on the B-Pillar or the edge of the
driver’s door. See Load Carrying for more information.

Note: The TPMS reset procedure needs to be performed after each tire
rotation on vehicles that require different recommended tire pressures in
the front tires as compared to the rear tires.

Overview

To provide the vehicle’s load carrying capability, some vehicles require
different recommended tire pressures in the front tires as compared to
the rear tires. The tire pressure monitoring system equipped on these
vehicles is designed to illuminate the low tire pressure warning light at
two different pressures; one for the front tires and one for the rear tires.

Since tires need to be rotated to provide consistent performance and
maximum tire life, the tire pressure monitoring system needs to know
when the tires are rotated to determine which set of tires are on the
front and which are on the rear. With this information, the system can
detect and properly warn of low tire pressures.

TPMS reset tips:
• To reduce the chances of interference from another vehicle, the TPMS

reset procedure should be performed at least three feet (one meter)
away from another Ford Motor Company vehicle undergoing the TPMS
reset procedure at the same time.

• Do not wait more than two minutes between resetting each tire sensor

or the system will time-out and the entire procedure will have to be
repeated on all four wheels.

• A double horn chirp indicates the need to repeat the procedure.
Performing the TPMS Reset Procedure

It is recommended that you read the entire procedure before attempting.

1. Drive the vehicle above 20 mph (32 km/h) for at least two minutes
and then park in a safe location where you can easily get to all four tires
and have access to an air pump.

2. Place the ignition in the off position and keep the key in the ignition.

Tires, Wheels and Loading

259

2012 F-150 (f12)
Owners Guide, 3rd Printing
USA
(fus)

Advertising
This manual is related to the following products: