FORD 2009 E-450 v.2 - Manual (Page 55)

Replacing headlamps (sealed beam)
1. Make sure the headlamp switch is in the off position and open the
hood.
2. Remove the four screws from the
top and bottom front of the
headlamp assembly and carefully
remove the lamp/bezel.
3. Remove the four screws and the
retaining ring.
4. Disconnect the electrical
connector from the lamp and
remove the lamp.
To install the new lamp, follow the
removal procedures in reverse order.
Replacing front parking lamp/turn signal bulbs
1. Make sure the headlamp control is in the off position.
2. Remove the headlamp assembly, refer to Replacing headlamp bulbs
in this section.
Aerodynamic
Sealed beam
2009 Econoline (eco)
Owners Guide, 2nd Printing
USA (fus)
Lights
55