Gate operator & canadian programming, Driver controls – FORD 2009 F-550 v.3 User Manual

Page 125

Advertising
background image

• If the indicator light blinks rapidly for two seconds and then turns

to a constant light continue with “Programming” Steps 4 through
6
to complete programming of a rolling code equipped device (most
commonly a garage door opener).

4. At the garage door opener receiver (motor-head unit) in the garage,
locate the “learn” or “smart” button (usually near where the hanging
antenna wire is attached to the unit).

5. Firmly press and release the “learn” or “smart” button. (The name and
color of the button may vary by manufacturer.)

Note: There are 30 seconds in which to initiate Step 6.

6. Return to the vehicle and firmly press, hold for two seconds and
release
the programmed HomeLink

௡ button. Repeat the

press/hold/release sequence again and, depending on the brand of the
garage door opener (or other rolling code equipped device), repeat this
sequence a third time to complete the programming.

HomeLink

௡ should now activate your rolling code equipped device. To

program additional HomeLink

௡ buttons begin with Step 1 in this section.

For questions or comments, please contact HomeLink

௡ at

www.homelink.com or 1–800–355–3515.

Gate Operator & Canadian Programming

During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink

௡ to accept the signal

from the hand-held transmitter.

After completing Step 1 outlined in
the Programming section, replace
Step 2 with the following:

Note: If programming a garage door opener or gate operator, it is advised
to unplug the device during the “cycling” process to prevent overheating.
• Continue to press and hold the HomeLink௡ button (note Step 2 in the

Programming section) while you press and release —

every two

seconds (“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink

௡. The indicator light will

flash slowly and then rapidly after HomeLink

௡ accepts the radio

frequency signal.

• Proceed with Step 3 in the Programming section.

2009 F-250/350/450/550 (f23)
Owners Guide, 3rd Printing
USA
(fus)

Driver Controls

125

Advertising
This manual is related to the following products: