Cal Spas 6300 - Manual (Page 21)

2008 Portable Spa Owner’s Manual Page 19
LTR20081000, Rev. B
Operating Your Spa
Adjustable Therapy System™
Pump On/Off
This button allows
the user to turn on
and off the ATS™
seat pump. Press
this button once to
turn the pump on.
Once on, the green
LED light on the
control
panel will
illuminate, indicating
that the system is
operational. To turn
off the pump, press the “PUMP ON/OFF” button a second
time. Note: The pump must be on prior to operating any
other features of this system.
Pulse Mode
This button allows the user to turn the ATS™ massage
control on and off. Press the pulse button once to turn
on the massage control. Once pressed, the orange LED
in position number 1will light, indicating the number one
pulse mode. Each press of either the up or down button
will move the orange LED up or down to the next pulse
mode.
Note: Allow one second between each button press.
Pressing the button quickly may cause improper
operation. To turn the pulse mode off and return to
normal pump operation, press the “PULSE MODE”
button a second time.
Up
This button allows the user to cycle up from one through
seven massage modes one at a time. Each mode
offers a different pulsating massage. Some modes are
faster than others, so just cycle through them to find the
massage you like best.
Down
This button allows the user to cycle down through all
seven massage modes, one at a time.
Time Reset Mode
Pulse mode will normally run for 15 minutes then
automatically shut off. For another 15-minute session,
press the “PUMP ON/OFF” button and the “PULSE
MODE” button. A green LED will blink and the pump
will run on high-speed mode as part of a 15-minute cool
down period. After that, the pump will stop automatically
and the green LED light on the panel will continue to
blink for one minute then shut off automatically. After the
second 15-minute session, the system will run through
a cool down cycle for up to two hours. In this cool down
mode, the user will only be able to operate the pump (by
again pressing the “PUMP ON/OFF” button). However,
the massage mode will remain off until the cool down
mode is completed.
Pulse Mode System
Pulse mode system will shut off for two hours unless
reset by the following procedure. During this time the
pump will run at a maximum speed.
In the off position, press the “PULSE MODE” button
once.
The green power light will flash to indicate reset.
Multi-Colored Spa Light
Operation
Turn the spa light on by pressing the “LIGHT” button
on the topside control panel.
To filter through the different color choices, press the
button on and off. Each time you press the button,
you advance to the next color.
To turn the spa light off when not in use, press the
“LIGHT” button.
Aromatherapy
This optional accessory is very easy to use. Unscrew
the cap on the aromatherapy chamber and drop in a bag
of scented aromatherapy beads and replace the cap.
Waterfalls
Some spa series include optional waterfalls. When the
booster pump is on, turn the knob near the waterfall,
or rotate the dial on top of the waterfall. Water will
immediately start flowing through it.
•
•
1.
2.
3.