FRIGIDAIRE FFES3015PS - Manual (Page 11)

11
Oven vent location
The oven vent is located through the upper front trim and
visible when the oven door is open. When the oven is on,
warm air passes through this vent. This venting is
necessary for proper air circulation in the oven and good
baking results. Do not block oven vent. Doing so may cause
cooking failures, fires, or damage to the range. Steam or
moisture may appear near the oven vent. This is normal.
Removing, replacing, and arranging flat or offset
oven racks
To Arrange - Always arrange the oven racks when the oven
is cool (prior to operating the oven).
To Remove - Pull the oven rack straight forward until it
reaches the stop position. Lift up front of oven rack slightly
and slide out.
To Replace - Place the oven rack on the rack guides on
both sides of oven walls. Tilt the front of oven rack upward
slightly and slide the oven rack back into place. Be sure
oven racks are level before using.
Type of oven racks
Oven Rack Descriptions
• Flat oven racks (or the flat handle oven rack) may be
used for most cooking needs and may be placed in
most oven rack positions.
• The offset oven rack (some models) provides additional
stepdown positions from the standard flat rack design.
The offset design positions the base of the rack about 1/
2 of a rack position lower than the flat rack and may be
used in most oven rack positions.
• To maximize oven cooking space, place the bottom
oven rack (some models) in the lowest rack position for
baking or roasting large cuts of meat.
Air circulation in the oven
For best air circulation when baking, allow a space of 2-4
inches (5-10 cm) around the cookware for proper air circu-
lation. Be sure pans and cookware do not touch each other,
the oven door, sides, or back of the oven cavity.
Hot air must be able to circulate around cookware for even
heat to reach the food.
Figure 5: Do not block oven vent location
Always use pot holders or oven mitts when using the
oven. When cooking, the oven interior and exterior, oven
racks and cooktop will become very hot which can cause
burns.
Protective Liners — Do not use aluminum foil to line the
oven bottom. Only use aluminum foil as recommended in
this manual. Improper installation of these liners may
result in risk of electric shock or fire.
CAUTION
WARNING
Figure 6: Oven rack types
Remove all oven racks and accessories before starting a
self-clean cycle. If the oven racks are left in the oven
during the self-clean cycle, they will lose their special
coating properties, may turn blue, and no longer slide in
and out of the oven cavity easily. If your model came with
porcelain-enameled racks, those may be left in the oven
during the self-clean cycle.
flat
oven rack
flat handle
oven rack
offset
oven rack
bottom
oven rack
IMPORTANT
BEFORE SETTING OVEN CONTROLS