FRIGIDAIRE FRA064VU1 - Manual (Page 3)

How to Install Installation
3
CENTER LINE INNER SILL
INDOOR
FIG. 6
Cut the FOAM STRIP to fit the underside of the window sash. Open the window, peel off the back and attach
the FOAM STRIP as shown in FIG.5
Mark center line with pencil on the center of the inner sill, as shown in FIG.6
3
2
FOAM
STRIP
FIG. 5
OUTDOOR INDOOR
inner sill
screw
leveling bolt
outer sill
support
bracket ablut 1/4"
FIG. 8
4
FIG. 7
SCREW
(ITEM D)
outer
window
sill
CLO P
OF SUPP B
(ITEM A)
screw
OLT
leveling bolt
adjustment slot
center line
of window
inner
winnow
sill
close-up view
of support bracket
Fail to securely install support bracket may result in unit falling from window if window sash is raised after unit is
installed. This could result in personal injury.
OUTDOOR INDOOR
window sash
indoor
section
top channel
FIG. 9
inner sill
outdoor
section
support
bracket
pocket
support
bracket
leveling bolt
outer sill
stopper
Install the air conditioner in the window
5
With the aid of an assistant, carefully lift the air
conditioner and slide it into the open window.
Make sure that support bracket is inserted in the pocket
under base fan, and that filler panels guide is stopped
by stopper on the support bracket as shown in FIG.9.
NOTE: When unit is properly centered and pushed
outward to correct bracket location, you will feel unit sit
securely in place on the support bracket. Hold unit
firmly during this procedure.
Lower top window sash all the way down so that sash
sits firmly in top channel of unit and expandable
curtain frames.
CAUTION: While performing the steps above, hold unit
firmly until window sash is lowered to top channel behind
filler panels. Personal injury or property damage may result
if unit falls from window.
Install support bracket on window sill. See FIG.7. Install leveling bolt up through bottom side of support bracket.
You can choose a short bolt or a long one according to window type. Also, you should select the position of
hole on bracket. Position bracket on sill of center line of window (See FIG.7). Fasten bracket loosely to sill
with screws provided. Adjust leveling bolt so that the air conditioner will be installed with a very slight tilt
DERXWƎ GRZQZDUGWRZDUGWKHRXWVLGHIRUSURSHUGUDLQDJH 6HH),* 7LJKWHQEUDFNHWVFUHZV