Contec SPI-8451-LVA - Manual (Page 22)

3. Hardware Installations
SPI-8451-LLVA, SPI-8452-LLVA, SPI-8451-LVA
15
3. Hardware Installations
This chapter provides information on how to use the jumpers and connectors on this product in order to
set up a workable system.
Installation procedure
(1) Confirm the power supply is off.
(2) Install the processor with correct orientation.
(3) Insert the DRAM module with correct orientation.
(4) Mount the fan on the top of the processor and connect it to FAN1 connector.
(5) Insert +12V Power Supply cable to PW1 connector.
(6) The jumpers are set up according to the conditions to be used.
(7) Insert all external cables except for flat panel. (Hard disk, floppy, keyboard, Mouse, LAN, etc.).
(8) Insert CRT or LCD monitor to VGA connector.
(9) Turn on the power.
(10) Enter the BIOS setup mode by pressing ‘Del’ key during boot up.
(11) Use the “Load BIOS Optimal Defaults” feature.
(12) Configure the Peripheral Setup and the Standard Setup correctly.
CAUTION
The CMOS memory may be in an undefined state at power-on after a period of no battery backup.