Cisco 300 User Manual
Page 11
300 Series Managed Switches
11
Back Panel
The power port and console port are located on the back panel of the
managed switch.
Power—The Power port is where you will connect the switch to power.
Console—The Console port is where you can connect a serial cable to a
computers serial port for configuration using a terminal emulation program.
Returning the Device to the Factory
Default Settings
To use the
Reset
button to reboot or reset the managed switch, do the
following:
• To reboot the managed switch, press the
Reset
button for less than 10
seconds.
• To restore the managed switch configuration to the factory default
settings:
1. Disconnect the managed switch from the network or disable all
DHCP servers on your network.
2. With the power on, press-and-hold the
Reset
button for more than
10 seconds.
5