Canon Pixma iP4300 - Manual (Page 88)

84 Troubleshooting
*1
To resume printing, you can also press the RESUME/CANCEL button on the printer instead of
selecting Continue on the camera.
*2
The ink absorber absorbs ink used during cleaning, for example. If this message appears, you will
need to call for servicing to replace the absorber and to check the printer for proper operation.
“Ink Error” If the ALARM lamp on the printer flashes orange thirteen times, an ink tank that
was once empty is installed.
Replace the ink tank and close the Top Cover.
Printing with an ink tank that was once empty may damage the printer.
If you want to continue printing in this condition, you need to release the function
for detecting the remaining ink level. Press and hold the RESUME/CANCEL
button for at least 5 seconds, and then release it.
* With this operation, releasing the function for detecting the remaining ink
level is memorized. Please be advised that Canon shall not be liable for any
printer malfunction or damage caused by refilled ink tanks.
See “Replacing an Ink Tank” on page 26.
“Hardware Error” When the ALARM lamp on the printer flashes orange fifteen times, an ink tank
error has occurred. Replace the ink tank. See “Replacing an Ink Tank” on
page 26.
“Printer error” An error requiring servicing may have occurred. (Printer POWER lamp flashes
green and ALARM lamp flashes orange alternately.)
Disconnect the cable between the printer and the camera, turn off the printer,
and unplug the power cord of the printer from the power supply. After a while,
plug the power cord of the printer back in, turn on the printer, and then
reconnect the camera to the printer.
If the same error occurs, contact your Canon service representative.
Error Message On Camera Action