Installation guidelines, Verifying package contents – Cisco 2940 User Manual

Page 33

Advertising
background image

2-3

Catalyst 2940 Switch Hardware Installation Guide

OL-6157-01

Chapter 2 Installation

Preparing for Installation

Installation Guidelines

When determining where to place the switch, observe these guidelines.

Before installing the switch, first verify that the switch is operational by powering it on and running
POST. Follow the procedures in the

“Verifying Switch Operation” section on page 2-4

.

For 10/100 ports and the 10/100/1000 port, the cable length from a switch to an attached device
cannot exceed 328 feet (100 meters).

For the 100BASE-FX port, the cable length from a switch to an attached device cannot exceed
6562 feet (2 kilometers).

Operating environment is within the ranges listed in

Appendix A, “Technical Specifications.”

Clearance to front and rear panels meet these conditions:

Front-panel LEDs can be easily read.

Access to ports is sufficient for unrestricted cabling.

Rear-panel AC power connector is within reach of an AC power outlet.

Airflow around the switch and through the vents is unrestricted.

Temperature around the unit does not exceed 113°F (45°C).

Note

If the switch is installed in a closed area, such as a wiring closet, the temperature around it
might be greater than normal room temperature.

Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent
lighting fixtures.

Verifying Package Contents

Note

Carefully remove the contents from the shipping container, and check each item for damage. If any item
is missing or damaged, contact your Cisco representative or reseller for support. Return all packing
materials to the shipping container and save them.

The switch is shipped with these items:

AC power cord

Mounting kit containing these items:

Four rubber feet for installing the switch on a desktop

Three number-8 Phillips pan-head screws for mounting the switch on or under a desk or on
a wall

Screw template for aligning screws

Magnet for mounting the switch on a metal surface

One RJ-45-to-DB-9 adapter (console port) cable

Catalyst 2940 Switch Getting Started Guide (order number DOC-7816576=)

Advertising