Canon VK-64 - Manual (Page 24)

Notes on Operating Environment
24
Note on Windows XP SP2
If your Storage Server is not installed on the same PC as your Viewer, you will need to
change your Windows firewall settings for the Storage Server on the PC with Windows
XP SP2.
* The following setting is not required if you are installing the Storage Server and Viewer
on one PC.
After installation of the Storage Server:
1. From the Windows Start menu, launch the Control Panel.
2. In Control Panel, select Windows Firewall. If Windows Firewall is not shown, select
Security Center and then select Windows Firewall.
3. In the Windows Firewall dialog, select the Exception tab and then click Add Port....
4. In the Add a Port dialog, enter a name for the Storage Server, e.g., “VK-64/VK-16
Storage Server”. Enter the Port number as “80”. Make sure the TCP protocol is
selected and click OK.
5. In the Windows Firewall dialog, your Storage Server is now listed. Make sure it is
enabled (checked). Click OK to close the dialog.
Settings are now complete.
If more than ten Camera Servers out of all registered ones cannot be connected to
Storage Servers, recording operations may take longer.