Canon VK-64 - Manual (Page 51)

Stora
g
e
S
er
ver
Configuration
Ref
erence
Setting the Settings Tab
51
3
●
Enter the Storage Server Proxy Address
If the Storage Server needs to access
Camera Servers outside the LAN, you
may need to configure proxy settings.
* See “When using a proxy server” (
➝ P. 11).
In the Storage Server Proxy
field, tick the Enable the
following proxy server box.
Enter the Proxy server address
and Port.
For more information on proxy server usage, see your Camera Server administrator.
2
1
●
Enter Recorded Video Settings
Maximum retained history -
Check the Maximum retained
history option and enter a value
from 1 to 999 and then select
Days or Weeks from the drop-
down menu.
Maximum file size/duration - Check the Maximum file size/duration option, enter
a value (e.g., “100” or “24”), and select MB or Hours. You can enter 32 - 1024 for
MB and 1 - 24 for Hours. This will establish the maximum size used for each file of
recorded video. If you do not enter a value, 1024 MB or 24 hours is used for the
Maximum file size/duration value.
Low disk space warning level - Enter a percent value.
When the remaining space falls below the specified value, the event will be
displayed and a notification will be e-mailed (
➝ P. 62, 64).
Reduce recording frame rate when disk is under high load - When disk is highly
loaded, recording frame rate is temporarily reduced to prevent the recording from
stopped. Refer to Chapter 6 for details.
4
3
2
1
When Reduce recording frame rate when disk is under high load
is checked, you will receive an event notification such as
Effective “Recording rate (<recording rate before change>
➝
<recording rate after change> %)”.
Ex. “Recording rate (100.0
➝ 90.0 %)”
Tip