Cisco Cisco Multiband Wall-Mount Antenna AIR-ANTM5560P-R User Manual

Page 11

Advertising
background image

11

Cisco Multiband Wall-Mount Antenna (AIR-ANTM5560P-R)

OL-6847-01

Installation Instructions

Figure 6

Mounting the Antenna on a Wall

To mount the antenna on a wall, follow these steps:

Step 1

Choose a location for mounting.

Step 2

If an extension coaxial cable is used, connect it to the access point and extend the coaxial cable to the
location for mounting the antenna.

Step 3

Attach the antenna to the molded antenna mount using the four provided 8-32 nylon lock nuts.

Step 4

Attach the antenna mount to the articulating arm (all mounting hardware is provided):

a.

Place a 1/4-in. lock washer, then a 1/4-in. flat washer on a 1/4-20 x 1-1/4-in. machine screw.

b.

Insert the screw and washers, first through the molded antenna mount, then the articulating arm.

c.

Secure the articulating arm to the molded antenna mount using a 1/4-20 hex nut.

Step 5

Find the molded wall mount and position it on the mounting surface. Use a pencil to mark the location
of the mounting holes. There are four holes for wall-mounting, one in each corner.

Step 6

Using a 3/16-in. (4.7 mm) drill bit, drill holes for the screws at the locations you marked in

Step 5

.

Step 7

Route the cable either up or down from the wall or corner.

Step 8

Install a wall anchor in each hole.

Step 9

Line up the mounting holes on the molded wall mount with the pilot holes and start one of the provided
8-18 x 3/4-in. self-tapping Phillips screws in each hole.

Step 10

Tighten the screws with a Philips screwdriver.

Step 11

Attach the articulating arm to the molded wall mount (all hardware is provided):

a.

Place a 1/4-in. lock washer, then a 1/4-in. flat washer on a 1/4-20 x 1-1/4-in. machine screw.

b.

Insert the screw and washers, first through the molded wall mount, then the articulating arm.

c.

Secure the articulating arm to the molded wall mount using a 1/4-20 hex nut.

1

Wall anchors

2

Molded wall mount

3

8-18 x 3/4-in. self-tapping Phillips screws

4

Articulating arm

5

Molded antenna mount

2

5

4

1

3

3

135159

Advertising