Craftsman SPIKER 486.24331 - Manual (Page 11)

11
• Place two 5/8" flat washers separated by a long
spacer tube onto the shaft. See figure 20.
FIGURE 20
SPIKE DISK
SHORT SPACER TUBE
• Place a spike disk and a short spacer tube onto the
shaft. Fit the short spacer tube onto the ends of the
flanged bearings in the spike disk and in the end
plate. Push the shaft on through the flanged bearing
in the end plate. See figure 21.
5/8" FLAT WASHER
LONG SPACER TUBE
FIGURE 21
FIGURE 23
• Place a 5/8" flat washer onto the end of the spike disk
shaft and secure the shaft with a 1/8" x 1-1/2" cotter
pin. See figure 22.
• Fasten the two drive disks to the shaft using two 1/8"
x 1-1/2" cotter pins. See figure 22.
5/8" FLAT
WASHER
1/8" x 1-1/2"
COTTER PIN
DRIVE DISKS
FIGURE 22
• Assemble the chain onto the two sprockets on the
left side of the hopper. Fasten the ends of the chain
together using the connecting link. See figure 23.
• Place the chain cover over the chain and fasten it to
the hopper end plate using two self tapping screws.
See figure 23.
CONNECTING
LINK
CHAIN
SELF
TAPPING
SCREW