Chicago Electric 1.5HP 7" Bridge Tile Saw 98265 - Manual (Page 12)

Page 12 For technical questions, please call 1-800-444-3353. SKU 98265
4.
Fig. 1
The Handle (B13) must be installed onto
the Holder (B09) using the two supplied
Hex Screws (B12). (See Fig. 1.)
5.
Fig. 2
Holding Clips
Be sure the water pump (A25) is
properly installed within its holding
clips (see Fig. 2). Run the water hose
from the pump discharge to the Blade
Cover (A30) and plug the pump power
cable into an outlet. The water from the
pump can now keep the blade wet for
proper cooling.
Mounting
This tool can be placed on a table or
other stable surface. The ideal method
would be to mount the tile saw on the
stand made for it, SKU 98328 (not in-
cluded, sold separately).
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at
the beginning of this manual
including all text under
subheadings therein before set up
or use of this product.
Work Piece and Work Area Set Up
1. Designate a work area that is clean and
well-lit. The work area must not allow
access by children or pets to prevent
distraction and injury.
2. Route the power cord along a safe route
to reach the work area without creating
a tripping hazard or exposing the power
cord to possible damage. The power
cord must reach the work area with
enough extra length to allow free move-
ment while working.
3. Secure loose work pieces using a vise or
clamps (not included) to prevent move-
ment while working.
4. There must not be objects, such as utility
lines, nearby that will present a hazard
while working.
REV 10b