Cisco Multiband Diversity Omnidirectional Ceiling-Mount Antenna AIR-ANTM4050V-R - Manual (Page 10)

10
Cisco Multiband Diversity Omnidirectional Ceiling-Mount Antenna (AIR-ANTM4050V-R)
OL-6485-01
Installation Instructions
Installation Instructions
The following sections contain procedures for installing the antenna on a suspended ceiling.
Mounting on Suspended Ceilings with Flush Mounted Tiles
The antenna is configured to mount to a suspended ceiling track with flush mounted tiles. Suspended
ceiling mounting clips are provided on the rear panel of the antenna. (See
Figure 7 .)
Figure 7 Suspended Ceiling with Flush Mounted Tiles
After you have selected a suitable location, follow these steps to mount the antenna:
Step 1 Make two small slots in the ceiling tile for the cables to pass through.
Step 2 Line up the antenna mounting clips with the ceiling track.
Step 3 Grasp the antenna with one hand and the track with the other while gently pushing the antenna until the
clips are securely attached to the track.
Step 4 Route the antenna cables into the space above the ceiling grid and connect them to the device or extender
cables.
Step 5 Replace the ceiling tiles.
Note You may have to trim some material from one of the tiles to accommodate the antenna cables.
1 Ceiling track 2 Suspended ceiling mounting clips
Side view
Top view
127077
2
1