Cisco Cisco Small Business Pro IP Phones SPA 525G - Manual (Page 102)

Using the Cisco SPA 500S Attendant Console
Using the Cisco SPA 500S
Cisco Small Business Pro IP Phone SPA 525G User Guide 99
6
Using the Cisco SPA 500S
The functions of Cisco SPA 500S buttons may differ depending on configuration.
However, in general, you can:
•
Monitor an extension by viewing its color. The LED color of a line button
gives you information about the line being monitored:
-
Green: The line is idle.
-
Red (steady): The line is in use.
-
Red (blinking): The line is ringing.
-
Orange (steady): The line is not registered; there is a problem with phone
connectivity.
- Orange (blinking): The line is not configured properly.
- Off: The line is not configured.
•
Transfer a call by pressing the line button on the Cisco SPA 500S when an
incoming call is ringing.
•
Dial a configured extension by pressing the green line button on the Cisco
SPA 500S.
•
Pick up a call ringing at the extension by pressing the flashing red line
button.
Monitoring the Cisco SPA 500S
To view the status of the Cisco SPA 500S, perform the following steps:
STEP 1 Press the Setup button.
STEP 2 Scroll to Status and press Select.
STEP 3 Scroll to Peripheral Status and press Select.
STEP 4 The status is shown in the “Att Cons” fields.