Setting the tcp/ip network configuration – Cisco IP/TV 3400 Series User Manual
Page 100
Chapter 4 Setting IP/TV Server Configuration Parameters
Setting the TCP/IP Network Configuration
4-2
Cisco IP/TV 3400 Series Servers User Guide
OL-4467-01
Setting the TCP/IP Network Configuration
You need to set the TCP/IP network configuration of each IP/TV Server so that it
can communicate on the network with other IP/TV components.
Note
Multicast must be enabled on your routers in order to use the scheduled programs
feature of IP/TV on more than one subnet. On-demand programs do not require
multicast.
To set your networking configuration, follow these steps on each IP/TV Server:
Step 1
Choose Start > Settings > Network and Dial-Up Connections > Local Area
Connection.
Step 2
Click the Properties button in the Local Area Connection Status window.
Note
Each server has TCP/IP installed. However, each is configured to use a
static IP address that is reserved for testing purposes. You must
reconfigure your server to use static IP addresses appropriate for your site
and subnet.
Step 3
Choose Internet Protocol (TCP/IP) and click the Properties button.
Step 4
Click the Use the following IP address radio button and then enter the IP address,
subnet mask, and default gateway.
Step 5
Do one of the following:
•
If you are using the Domain Name System (DNS), enter the appropriate
information for the preferred and alternate DNS servers and click OK.
•
If you are not using DNS, populate the C:\winnt\system32\drivers\etc\hosts
file with the IP address and name of the server. See