Cisco IP/TV 3400 Series - Manual (Page 114)

Appendix C Instructions for Recovering IP/TV Servers
Recovering Cisco IP/TV 3426 and 3427 Servers
C-2
Cisco IP/TV 3400 Series Servers User Guide
OL-4467-01
Step 3 Press any key to continue.
The image is copied to the boot partition, and IP/TV Server reboots automatically.
This procedure takes about 5 minutes. When the logon message box appears,
IP/TV Server is ready.
Step 4 Configure IP/TV Server.
For specific instructions, see Chapter 4, “Setting IP/TV Server Configuration
Parameters.”
Recovering Cisco IP/TV 3426 and 3427 Servers
This section discusses how to recover a corrupted system image, how to recover
from missing disk-based software, and how to recover from catastrophic failure
on Cisco IP/TV 3426 and 3427 Servers.
Cisco provides disaster recovery CDs with Cisco IP/TV 3426 and 3427 Broadcast
Servers. These are DOS-bootable CDs that you can use to restore Cisco IP/TV
3426 and 3427 Servers to the shipping configuration and install the Windows
2000 operating system and Cisco IP/TV software. Use the disaster recovery CD
only to solve catastrophic software failures, and not to troubleshoot any problems
caused by user-specific configurations.
Recovering Cisco IP/TV 3426 Server
To restore Cisco IP/TV 3426 Server to the shipping configuration, follow these
steps:
Step 1 Insert the disaster recovery CD in the CD-ROM drive.
Step 2 Reboot IP/TV Server.