Cisco IP/TV 3400 Series - Manual (Page 79)

3-17
Cisco IP/TV 3400 Series Servers User Guide
OL-4467-01
Chapter 3 Installing the IP/TV Server
Installing Cisco IP/TV 3426 Broadcast Server Units
Step 9 Attach the power cords and the Ethernet cables to the IP/TV Server.
Because the IP/TV Server does not contain cable retention brackets or cable strain
relief brackets, you must first bundle the external cables before you route them.
Note Leave enough slack in the cables to allow for sliding the IP/TV Server in
or out of the cabinet.
To remove the IP/TV Server from the rack, reverse these instructions. Store these
installation instructions with your IP/TV Server documentation for future use.
Connecting Cables
To connect network, monitor, keyboard, and mouse cables to your IP/TV Server,
follow these steps:
Step 1 For network connections, insert a Category 5 UTP cable into the Ethernet 1 or
Ethernet 2 receptacle on the IP/TV Server back panel. (See
Figure 3-15 .)
Step 2 Connect the other end of the network cable to a hub or switch in your
network.
Step 3 For monitor connections, plug the monitor cable into the onboard video port of
the IP/TV Server back panel. (See
Figure 3-15 .)
Step 4 Connect the other end of the monitor cable to a monitor.
Step 5 Plug the keyboard and mouse cables into the keyboard port and mouse port,
respectively. (See
Figure 3-15 .)