Cisco 3550 - Manual (Page 79)

D-7
Catalyst 3550 Multilayer Switch Hardware Installation Guide
OL-6155-01
Appendix D Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
After you complete the setup program, the switch can run the default configuration that you created. If
you want to change this configuration or want to perform other management tasks, use one of these tools:
• CLI
• Device manager from your browser (for one switch)
• Network Assistant (for one or more switches)
To use the CLI, enter commands at the Switch> prompt through the console port or through the network
by using Telnet. For configuration information, see the switch software configuration guide or the switch
command reference.
To use the Network Assistant, see the Getting Started with Cisco Network Assistant guide.