PulseTech SP-5 12V Solar Battery Charger Maintainers (735X305) User Manual

Ulse, Ul ulse, Olar

Advertising
background image

I N S TA L L AT I O N M A N U A L

P

ULSE

PP

UL

ULSE

S

OLAR

S

OL

OLAR

INDUSTRIAL SOLAR CHARGING SYSTEM

TM

Congratulations, you’ve just purchased one of

the most effective methods available for keeping

your 12-volt lead-acid batteries charged — the

SolarPulse Industrial Solar Charging System.

Now you can charge, clean and even extend

the life of your 12-volt lead-acid batteries with

this one unique, solar-powered system. Besides

charging your battery, it also provides a constant

electronic dc pulse that removes sulfates on the

battery plates and returns them to the electrolyte.

By simply cleaning the plates, this system

extends battery life, maintains peak battery effi-

ciency, increases charge acceptance so batteries

recharge faster and last longer.

SolarPulse is ideal for all 12-volt lead-acid bat-

teries on vehicles and equipment in isolated situ-

ations where electrical power is not available.

This system will save you time, money and

effort by reducing battery-related downtime,

maintenance and replacement.

Installing SolarPulse is easy, just follow the

simple instructions to the right.

For Models

SP-2 & SP-5

WARNING: Because of the possibility

of personal injury, always use extreme

caution when working with batteries.

I. Mounting The Circuit Box

NOTE: The SolarPulse models can be used with the

circuit box mounted or unmounted on your vehicles

or equipment because it comes with a quick-discon-

nect. If you leave it unmounted, MAKE SURE to sep-

arate the quick-disconnect on the wires BEFORE

using the vehicle. Then reconnect the wires after

storing your vehicle again.

To mount the circuit box, use the following steps.

Mount the box close to the battery so that the lugs

can reach the battery terminals. DO NOT attach it to

the battery itself. MAKE SURE the box is situated in

a location where it is protected & will not accidental-

ly be disturbed by mechanics, etc.

The circuit box can be mounted in one of two ways:

1st Method: For a permanent installation, use two

round head screws (not included) to attach the cir-

cuit box to the side of the engine wall or battery

compartment or in another area away from moving

engine parts.

2nd Method: Use an industrial adhesive by applying

it to the back of the circuit box & then gluing the box

to the side of the engine wall near the battery.

Once the circuit box has been mounted, use plastic

cable ties (not included) to secure the SolarPulse

wires to a cable or other secure area near the battery.

This will keep the wires from tangling with moving

engine parts.

Continued inside.

1100 S. Kimball A

venue

Southlake, T

exas 76092

Please

Attach

Stamp

Print Retur

n Addr

ess

Advertising
This manual is related to the following products: