Canon 700 Series - Manual (Page 161)

Setting Up and Using a Standard Relay Unit 6-8
Using a Rela
y Netw
or
k
6
4
Enter the two digit relay group number that you want to
change using the numeric keys
➞ press [Set].
You can also press [
▼] or [▲] to select a relay group number.
The prompt <PASSWORD> will be displayed if you have previously set a
password. Proceed to step 5. Otherwise, proceed to step 6.
5
Enter the password (up to seven digits) using the numeric
keys
➞ press [Set].
If you have not previously set a password, proceed to step 6.
6
Press [
▼] or [▲] to display the setting you want to change ➞
press [Set].
To change the settings for an item, follow the same procedure you used for the
initial setup of the relay group. (See “Setting Your Machine as a Relay Unit,” on p.
6-3.)
NOTE
• To delete an item, press
(Clear)
➞ (Set).
• To turn ‘OFF’ the relay feature for the group and retain the group setup, press [
▼] or
[
▲] to display <10.RELAY B’CAST> ➞ press (Set), and turn this feature ‘OFF’.
You do not have to delete the relay group to disable it temporarily.
• To change the password for your relay group, you have to first enter the old
password (it is not displayed as you enter it)
➞ press (Set) ➞ enter a new
password (it is displayed as you enter it)
➞ press (Set).
7
When you are finished making changes, press [Stop] to return
to the Standby mode.
➞
➞
4
1
7
5
2
8
6
3
9
0
Set
4
1
7
5
2
8
6
3
9
0
Set
Set
C Set
Set
Set
Set
Stop