Canon 700 Series - Manual (Page 245)

Setting Up and Using PIN Codes 10-8
10
Other Special F
eatures
Dialing with a PIN Code after the Number
If you set <NECESS. PIN CODE> of the PIN Code setting to ‘OFF’, you can
perform the procedure described below. (See “Setting a PIN Code,” on p. 10-6.)
1
Place your documents on the machine.
For instructions explaining how to place your documents on the machine, see
“Setting the Document on the Machine,” on p. 3-3.
NOTE
• You can adjust the resolution, contrast, and document type for scanning. (See
“Adjusting the Scan Settings,” on p. 3-4.)
• You can also specify a sender’s name with [TTI Selector]. (See “Selecting a
Sender’s Name,” on p. 3-6.)
2
Enter the telephone number using the numeric keys.
3
Open all three one-touch speed dialing panels
➞ press
[Pin Code].
4
Press [Set].
NOTE
Repeat steps 2 through 4 for each telephone number in a sequential broadcast. In
a sequential broadcast, you must dial the second destination within five seconds of
dialing the first destination. All subsequent destinations must be specified within 10
seconds of each other. For details about sequential broadcasting, see “Sequential
Broadcasting to More Than One Location,” on p. 3-26.
4
1
7
5
2
8
6
3
9
0
Pin Code
Set