Shock Doctor Ultra2 STC Mouthguard - Manual

WARNING!
NOT FOR USE WITH BRACES
DO NOT CHEW YOUR MOUTHGUARD
In order for a mouthguard to protect, fit, and last it must be worn properly
on your teeth and gums as indicated in the fitting instructions. If any
mouthguard is chewed or not worn properly, its protection, fit and
durability will be greatly diminished.
FITTING INTRUCTIONS:
1. Fill saucepan with 3 to 4 inches of water. Bring water to a boil.
2. Remove water from heat source. Immediately place mouthguard
in water for 90-120 seconds. Do not remove before 90 seconds.
3. Carefully remove mouthguard from hot water with a slotted spoon.
4. Cool mouthguard under tap water for 1-2 seconds only to bring surface
temperature to a comfortable level.
5. Lick your lips before placing mouthguard in your mouth.
6. Watching in mirror, line up mouthguard carefully with the centerline of
upper teeth. Fit mouthguard onto and around upper teeth and press
firmly into molars first then front teeth.
7. Bring lower jaw forward and up into base of mouthguard with teeth in
alignment with lower channel.
8. Close mouth while biting down hard on mouthguard. Suck in strongly and use
fingers to press edges of mouthguard into teeth and gum line through lips and
cheeks for 20 seconds.
9. Remove mouthguard and cool under tap water for 30 seconds. Replace
into mouth and test for a good, firm fit.
10. Repeat steps 1 through 9 if fit is not accurate.
©2012 Shock Doctor, Inc.
TO FIT THIS MOUTHGUARD YOU WILL NEED:
> Ultra 2 STC Mouthguard
> Saucepan
> Boiling water
> Slotted spoon > Cold tap water
> Mirror
> A clock or watch with second hand
®
ULTRA 2 STC
DENTAL WARRANTY DISCLAIMER