Kit contents, Required tools, Caution – Tomei Powered 3.692 FINAL GEAR SET (R34) User Manual
Page 7: Warning
KIT CONTENTS
Below is the contents of this kit with the quantity listed in brackets ().
REQUIRED TOOLS
These tools are the bare minimum required for the job.
・NISSAN Workshop Service Manual
<Please prepare for ease of installation>
・General Engine Maintenance Tools
・Bearing Puller
・Torque Wrench
・Drift
・Dial Gauge
・Red Gear Marking Compound
・Flange Wrench
・Thread lock paste
・Liquid Gasket
・Pre Load Gauge
<These stock OEM parts will be needed for completing the installation>
Front (Compatible with 32~34)
REAR
・Drive Pinion Nut
38216-U301A(1)
・Drive Pinion Nut (32~34 Compatible)38216-U301A(1)
・Pinion Seal
C8189-03V00(1)
・Pinion Seal (32~34 compatible)
38189-N3112(1)
・Side Seal.
38342-03V11(1)
※Only for BNR32 up to '91/07 8189-21G00(1)
・Side Seal
38342-03V01(1)
・Side Seal Part No.
BNR32
38342-N3100(2)
BCNR33
38342-P9000(2)
BNR34 99 Jan~99 Oct models 38342-P9000(2)
BNR34 99.10 onwards models 38342-P9010(2)
BNR34 V-SPEC
38342-15U00(2)
FRONT DRIVE PINION (1)
FRONT CROWN RING GEAR (1)
REAR CROWN RING GEAR (1)
7
BNR34 V-SPEC
38342-15U00(2)
CAUTION
■ This manual is only to be used as a supplement reference guide only. This manual does not provide the
complete installation procedure. For detailed instructions on the procedure, please refer to the official Nissan
workshop service manual.
■ These products are designed to be used for off road competition purposes only.
■ This product is to be installed by a qualified professional in a fully equipped workshop.
■ This product was designed specifically for the application specified.
■ If the attempt was made to use this product on another engine/car other than specified then you will risk
damaging this kit and or the engine or components related with it.
■ Do not use any excessive force when using this product as you risk damaging the product or other parts.
■ This product is to be installed with the appropriate tools and equipment to prevent any engine failures and
injuries or bodily harm.
WARNING
■
Install the product only when the engine & drive train is cold.
■
Due to the nature of the area where the product's) is installed. Please exercise caution to prevent any
possible fire hazards from oil etc.
7