Trail Tech X2 KIT: HALOGEN YAMAHA 36T2C-70 User Manual

Features and wiring rubber mounting straps, Lower mounting pins

Advertising
background image

010-ELV-75

X2

Tech Support: 360-687-4530

[email protected]

X2

FEATURES AND WIRING

RUBBER MOUNTING STRAPS:

RUBBER MOUNTING STRAPS:

The two rubber straps wrap around the forks.
They hold the light to the motorcycle and
extend the life of the light by providing
anti-vibration isolation. Rubber straps install
with no tools. Use isopropyl rubbing alcohol
as lubricant when attaching the rubber straps
to the light. Take care not to rip or tear.

LOWER MOUNTING PINS:

A) O.E.M. MOUNTING PINS:

Some motorcycles (KTM) arrive from the manufacturer with
mounting pins built in (Fig.1). If they are present, use them.

MOUNTING PINS:

There are four holes on the bottom of X2. 2 pins go through the
holes to secure the bottom of X2 to the fender. Choose between
the forward or rear holes to aim X2’s beam. The pins reduce
“excessive play” commonly found with other mounting techniques.
There are several pin options:

B) MOUNTING PLATE:

Some motorcycles (CRF450R, WR450) arrive from the
manufacturer with the fender bolted to the triple tree (with a
56-60mm bolt spacing and M6 bolts.) Sandwich the included
mounting plate between the triple tree and fender, providing
mounting pins for X2. Use Loctite thread locking compound to
ensure the triple tree bolts do not back out during riding.

C) DOWN-PINS:

If option A or B will not work, use the included “down pins.” To
install, place X2 on the motorcycle using the rubber fork straps.
Turn on X2 and aim the beam to the desired height. Determine
which set of holes to use on X2 (the down-pins are reversible,
side specific, and usually look best if the screw is to the rear of the
light, as shown in Fig.3.) Use a marking pen to mark where two
holes should be drilled in the fender. Remove the light from the
motorcycle and drill the two 8mm (5/16”) holes. Screw the down
pins to X2 as shown in (Fig.3). X2 should now have two pins that
fit into two drilled holes on the fender.

Fig.3

Fig.2

Fig.1

The down-pin drill template to the right may

be used if using the down-pin option.

1. Mount X2 using fork straps, align beam angle.
2. With beam angle in place, center X2 right-left
on the fender. Cut out and tape down-pin drill
template in correct position on fender.
3. Drill down-pin holes and install X2.

Drill 1 set of holes ONLY. Drilling 2 sets of

holes can cause fender plastic to break out.

8mm

(5/16”)

DRILL SIZE

82.3mm

(3-1/4”)

DISTANCE BETWEEN HOLES

Advertising