Trail Tech KICKSTAND 5013-KTM - Manual

5013-KTM/5300-10 5301-00/5301-10
KicKsTand insTallaTion
00-04 KTM 250-525 sX/MXc/EXc
05-07 KTM 250-525 MXc/EXc/Xc/Xc-W
05-06 KTM 250-450 sX/sXF
010-ElV-149
TRail TEcH KicKsTands
Tech Support: 360-687-4530
[email protected]
2004 KTM 450SX Kickstand Installed
1. Remove the 8mm lower chain guide bolt & nut.
2. Remove the lower rear sub-frame bolt.
3. Attach mounting bracket to frame as shown to
right using the M8 bolts provided. (Use thread locking
compound on the pivot bolt to ensure it does not back
out.)
4. Hang spring as shown.
00-04 KTM 250-525 sX/MXc/EXc
Replacement Kickstand arm Kits for KTM:
KTM EXC/MXC (Stand and 8mm Bolt Only) 98-01
5003-KTM
KTM EXC/MXC (Stand and 8mm Bolt Only) 02-07
5003-KTM-A
Remove stock kickstand. Install Trail Tech kickstand
using stock mounting points, spring and the included
8mm pivot bolt. Use thread locking compound on the
pivot bolt to ensure it does not back out.
05-07 KTM 250-525 MXc/EXc/Xc/Xc-W
05-06 KTM 250-450 sX/sXF
1. Remove the 8mm lower chain guide bolt & nut.
2. Remove the lower rear sub-frame bolt.
3. Attach mounting bracket to frame as shown to
right using the M8 bolts provided. (Use thread locking
compound on the pivot bolt to ensure it does not back
out.)
4. Hang spring as shown.
5013-KTM/5300-10 5301-00/5301-10
LIMITED WARRANTY
Trail Tech inc. warranTS Trail Tech KicKSTanD proDUcTS To be free
from DefecTS in maTerial anD worKmanShip UnDer normal USe anD if
properly inSTalleD for a perioD of Six monThS from DaTe of pUrchaSe.
if foUnD To be DefecTive aS menTioneD above, iT will be replaceD or
repaireD. ThiS Shall conSTiTUTe The Sole remeDy of The pUrchaSer
anD The Sole liabiliTy of Trail Tech inc. To The exTenT permiTTeD by
law, The foregoing iS exclUSive anD in lieU of all oTher warranTieS or
repreSenTaTionS wheTher expreSSeD or implieD, inclUDeD any limiTeD
warranTy of merchanTabiliTy or fiTneSS. in no evenT Shall Trail Tech
inc. be liable for Special or conSeqUenTial DamageS.
iMPoRTanT: WEaR EYE
PRoTEcTion WHEn HanGinG
sPRinGs!
note: After every ride it is important to check your kickstand
thoroughly for the following:
• Loose or damaged bolts • Bent or damaged kickstand leg or
bracket • Damaged spring
Damaged or broken parts can result in serious injury! If any part of
your stand has become
damaged do not ride the machine! Contact a factory trained
technician or Trail Tech directly for service or repairs.