Trail Tech REPLACEMENT OEM KICKSTAND 5310-00 - Manual

STEP 1
Place bike on stand. Unbolt factory kickstand arm and re-
move from bike. Remove OEM shim from kickstand
mounting boss on bike frame.
Save for reinstallation
later.
STEP 2
Unscrew spring hanger from factory kickstand arm.
Replace the old screw using the supplied M5 screw. Do
not bend or damage the spring hanger.
STEP 3
Install spring hanger on new arm, ensuring proper spring
hanger orientation. (See picture)
IMPORTANT - Thread-
locker MUST be used on this bolt. Torque to 5-7 Nm (45-
62 in-lbs).
STEP 4
Place new kickstand leg on frame boss. The leg will not
seat fully due to paint on the mounting boss. Loosely
thread supplied M8 kickstand pivot bolt into frame boss
(finger tight). Rotate the kickstand arm through its travel
while slowly threading in the pivot bolt. Repeat process if
necessary until arm rotates freely without sticking.
010-ELV-166
Tech Support: 360-687-4530
[email protected]
KTM OEM Replacement Kickstand Leg
Frame Boss
Frame Face
Shim