Two Brothers Racing Kawasaki Concours 14 User Manual

V.a.l.e, Concours 14

Advertising
background image

V.A.L.E.

V a r i a b l e a x i s l o c k i n g e x h a u s t

TM

Parts List

IMPORTANT - PLEASE READ CAREFULLY

Warranty

two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as is”

without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a particular

purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use

of these products or parts.

We recommend that this performance part be installed by a qualified

motorcycle technician. If you have any doubts as to your ability to install this

performance part, please consult with your local motorcycle dealer. Read all

instructions first before starting installation. Make sure the motorcycle and

exhaust system are completely cool before starting the installation. Also,

make sure the bike is secure on a centerstand or ideally a service lift during

installation. Be sure to save all stock components for possible use later.

Installation Instructions

2008-10 Kawasaki

ConCours 14

V.A.L.E.™ Slip-on Exhaust System with M-5 Canister
Part # 005-1920419V, 005-1920420V

Qty.

Description

Part Number

1

M-5 Muffler Canister

Varies

1

Stainless Steel S-Bend Slip-On Tube

005-19201S

1

Muffler Clamp

Varies

1

HARDWARE KIT

005-192-3

2

X-Ring (half)

005-7-2-3

1

Muffler Bracket

005-69B-10

1

Barrel Clamp

005-27-66MSH

1

8x20mm Flange Bolt

005-FB820

1

8mm Flange Nut

005-FN8

1

5mm Long Handle Ball end hex key

005-9-18610

4

6x14mm Socket Head Cap Screw

005-SH614

4

M6 Split Lock Washer

005-WL6

1

TBR Sticker Kit

015-10212

1. Make sure the bike is completely cool before starting the

installation. Make sure the bike is secure on center stand or
ideally a service lift.

2. Remove the OEM muffler:

- Remove lower mounting bolt.

- Loosen header joint clamp.

- Remove upper mount bolt.

- Remove OEM muffler and slip tube. *If gasket
remained on header it must be removed as well and
will not be re-used

3. Install Two Brothers Racing Slip-on Exhaust System:

- Attach the mid-pipe to the muffler using the 4 (four)
6x14mm socket head caps screws and split lock
washers provided. Leave loose for now.

-

Install center stand rubber bumper (use the OEM
rubber bumper and install it onto the TBR slip-tube
bracket).

- Slide provided barrel clamp over mid-pipe.

- Install the muffler bracket (with the 10mm hole on the
top) to the upper mount using the OEM hardware to
attach. Use the supplied flange bolt and nut to attach
the lower mount.

- Attach the rubber lined muffler clamp and tighten.

- Make sure muffler is aligned when the bike is on
the center stand. Also keep even clearance between
the muffler and luggage bag. Then tighten the four
V.A.L.E.™ assembly bolts.

- Tighten barrel clamp.

- Re-check all hardware and fitment.

Muffler Inlet

X-Lite™ Ring

Slip Tube

V.A.L.E.™ Assembly Detail

Advertising