Two Brothers Racing Suzuki SV-650 User Manual

V.a.l.e, Juice box™ - fuel controller, Two brothers racing

Advertising
background image

Two Brothers Racing

Juice Box™ - Fuel Controller

2007-08 Suzuki SV650 Installation & Operation Manual

Part # 008-101

Parts Incuded

Installation Instructions

Qty.

Description

Part Number

1

Juice Box™ Fuel Control Kit

008-101

(#9120092)

3

Zip Ties

1

Adhesive Velcro Square

V.A.L.E.

V a r i a b l e a x i s l o c k i n g e x h a u s t

TM

Gently lift gas tank up and insert tank prop rod as shown

in (Fig 5).

You will need to remove the air box assy. First disconnect

the (3) connectors as shown (Fig 6) then loosen both air

box throttle body clamps (Fig 7), and any hoses that are

attached to the bottom of the air box and remove. (Fig 8)

We recommend placing the JUICE BOX™ on dash left

hand side, so you will need to route the JUICE BOX™

wires down the center fairing stay, (Fig 9), and towards

the inside of the RH fork tube and through the opening in

the frame, (Fig 10). Once you have the wires on the inside

of the bike follow the bikes wiring towards the middle of

the bike. (Fig 11). The JUICE BOX™ can also be mounted

in the tail section of the SV. Routing of the JUICE BOX™

wires must be feed from the tail section up to the throttle

bodies, following the stock wiring harness.

6.

7.

8.

IMPORTANT - PLEASE READ CAREFULLY

Warranty

two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original

defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers

racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.

to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of

original purchase.

We recommend that this performance part be installed by a qualified motorcycle

technician. If you have any doubts as to your ability to install this performance part,

please consult with your local motorcycle dealer. Read all instructions first before

starting installation. Make sure the vehicle and exhaust system are completely cool

before starting the installation. Also, make sure the vehicle is secure during installation.

Be sure to save all stock components for possible use later.

The Juice Box™ is legal ONLY for closed course race vehicles. The Juice Box™ is not

applicable, nor inteded for use on EMISSIONS CONTROLLED street, highway or off-road

vehicles. The Juice Box™ is not applicable, nor inteded for use on aircraft.

Thank you for purchasing a genuine Two Brothers Racing

JUICE BOX™. This product represents a radical step

forward in tuning fuel-injected motorcycles and ATVs for

optimal performance using “load-based” technology.

We at Two Brothers Racing hope that you will find this

development as exciting and useful as we do. And

remember: Proper Fuel = Maximum Power!

Make sure the vehicle is completely cool before starting

the installation. Also, make sure the vehicle is secure and

will not roll around.

Remove passenger seat and remove tank prop rod from

inside tail section it will be needed later on.

Remove small side panels (Fig 1-2) on both sides.

Remove seat bolts (Fig 3) and remove rider seat.

Remove the front (2) tank bolts (Fig 4).

1.

2.

3.

4.

5.

Tools Needed For Install

- Long Angled Needle-nose Pliers
- Long Phillips Screwdriver
- 3-5mm Allen Wrench

Continued on page 2

Fig 1

Fig 2

Fig 3

Fig 4

Fig 5

Fig 6

Fig 7

Fig 8

Fig 9

Fig 10

Fig 11

Advertising