Setting nortel radius parameters for a user – Cisco 3.3 User Manual

Page 295

Advertising
background image

7-49

User Guide for Cisco Secure ACS for Windows Server

78-16592-01

Chapter 7 User Management

Advanced User Authentication Settings

Step 3

In the Microsoft RADIUS Attributes table, to specify the attributes that should be
authorized for the user, follow these steps:

a.

Select the check box next to the particular attribute.

b.

Further define the authorization for that attribute in the box next to it.

c.

Continue to select and define attributes, as applicable.

For more information about attributes, see

Appendix C, “RADIUS

Attributes”

, or your AAA client documentation.

Note

The MS-CHAP-MPPE-Keys attribute value is autogenerated by
Cisco Secure ACS; there is no value to set in the HTML interface.

Step 4

Do one of the following:

If you are finished configuring the user account options, click Submit to
record the options.

To continue to specify the user account options, perform other procedures in
this chapter, as applicable.

Setting Nortel RADIUS Parameters for a User

The Nortel RADIUS parameters appear only if all the following are true:

A AAA client is configured to use RADIUS (Nortel) in Network
Configuration.

The Per-user TACACS+/RADIUS Attributes check box is selected under
Advanced Options in the Interface Configuration section.

User-level RADIUS (Nortel) attributes you want to apply are enabled under
RADIUS (Nortel) in the Interface Configuration section.

Nortel RADIUS represents only the Nortel proprietary attributes. You must
configure both the IETF RADIUS and Nortel RADIUS attributes. Proprietary
attributes override IETF attributes.

Advertising