Sony CPD-L181 - Manual (Page 12)

Customizing Your Monitor
I
For vertical adjustment, select V using the
buttons and adjust the position using the +/-
buttons.
+ ... to move the picture up
- ... to move the picture down
CENTER
(3
B 26 a
5 When you have finished, click [ e W| on the screen to
turn off the test pattern.
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button twice.
Adjusting the Picture Brightness
Once the brightness is adjusted, it will be stored in memory
for all input signals received.
1 Press the 0 (brightness) {h button.
The BRIGHTNESS OSD appears.
BRIGHTNESS
D-
\^m
B 26 B
48 . 4 kHz / 60 Hz
t___________ t ____
Horizontal Vertical
Frequency* Frequency*
2 Press the +/- buttons.
3 + ... for more brightness
- ... for less brightness
The OSD automatically disappears after about 3 seconds.
* The horizontal and vertical frequencies for the received input
signal appear in the BRIGHTNESS OSD.
If the screen is too bright when using the monitor in a
dark room
Decrease the BACKLIGHT (page 15).
Adjusting the Contrast
Once the contrast is adjusted, it will be stored in memory for
all input signals received.
1 Press the 3 (contrast)'!} button.
The CONTRAST OSD appears.
CONTRAST
B 26 B
48 . 4 kHz/ 60 Hz
Horizontal Vertical
Frequency* Frequency*
2 Press the +/- buttons
3
+... for more contrast
-... for less contrast
The OSD automatically disappears after about 3 seconds.
* The horizontal and vertical frequencies for the received input
signal appear in the CONTRAST OSD.
Changing the Picture Size
According to the Signal
The monitor is set at the factory to display the picture on the
screen in full, irrespective of the picture's mode or
resolution. You can also view the picture at its actual aspect
ratio or resolution. Note that 1280 x 1024 resolution signals
fill the entire screen and ZOOM is not possible.
Once the zoom is set, it will be stored in memory for the
current input signal.
FULL 1
The input signal is displayed on the screen in full,
irrespective of the picture's mode or resolution.
FULL 2
The input signal is displayed on the screen at its actual
aspect ratio. Therefore, black bands may appear at the
top and bottom of the picture depending on the signal.
REAL
The input signal is displayed on the screen at its actual
resolution. (Sub-SXGA signals are displayed at the center
of the screen surrounded by black frame.)
12