Sony PCV-230 - Manual (Page 3)

Regulatory Information
Declaration of Conformity
Trade Name: SONY
Model No.: PCV-210/PCV-230
Responsible Party:
Sony Electronics Inc.
Address:
I Sony Drive
Park Ridge, NJ 07656
Telephone No: 201-930-6970
This device complies with Part 15 of
FCC Rules. Operation is subject to
the two following conditions: (1)
This device may not cause harmful
interference, and (2) this device
must accept any interference
received, including interference that
may cause undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
□ Reorient or relocate the receiving
antenna.
□ Increase the separation between the
equipment and the receiver.
□ Connect the equipment into anoutlet
on a circuit different from that to
which the receiver is connected.
□ Consult the dealer or an experienced
radio/TV technician forhclp.
You are cautioned that any changes or
modifications not expressly approved in
this manual could void yourauthority to
operate this equipment.
Only peripherals (computer input/output
devices, terminals, printers, etc.) that
comply with FCC Class B limits may be
attached to this computer product.
Operation with non-compliant peripherals
is likely to result in interference to radio
and television reception.
All cables used to connect peripherals must
be shielded and grounded. Operation with
cables, connected to peripherals, that are
not shielded and grounded, may result in
interference to radio and television
reception.