Sony DVP-C650D - Manual (Page 60)

Speaker Set Up
i/t
n
3
(fi
VI
fi;
3
a
>
a.
c‘
VI
3
n
3
RiMr spcakci' positiini (Kl AK/ SIPF)
Tlu'so items lot vou spooit\- the location of vour roar speakers tor
proper implementation ot'A’lRTL AL REAR SHUT” and
'A lKELkAl Mi l Tl REAR" in tlie Control Menu displav. Refer to
the illustration below.
• Set to "SIUI-" it the location ot \ our rear speakers corresponds
to sectiori
• Set tt> "RE AR" it the location i>t vour rear speakers correeponds
til section B.
This settini; ettects onl\ tlie 'A'lRTL'AE REAR SI IIET" and
A’lRTUAE ML’ETI REAR" mode.
[3] CD
Notes
• When you select un item, the sound cuts off for a moment.
• The cut off frequency for the subwoofer is fixed at lOOHz.
• Set the subwoofer's cut off frequency as high as possible.
• Depending on the settings of other speakers, the subwoofer
may output excessive sound.
• If your speakers are tor) small to reprrtduce ir)w bass
frequencies, set all speaker settings to "SMALL" and utilize a
subwoofer for low frequency sound.
■ DISTANCE
You can vary the distance of each speaker as follows.
Default adjustments are in the parentheses.
• FRONT (12ft/3.6m)
Front speaker distance can be set in 1 foot/0.3 meter
steps from 4 to 50 feet/1.2 to 15.2 meters.
• CENTER (12ft/3.6m)
Center speaker distance can be set in 1 foot/0.3 meter
steps from a distance 2 feet/0.6 meter farther to the
front speaker to a distance 5 feet/1.6 meters closer to
your listening position.
• REAR (10ft/3.0m)
Rear speaker distance can be set in 1 foot/0.3 meter
steps from a distance equal to the front speaker distance
to a distance 16 feet/5 meters closer to your listening
position.
Notes
• When \ ou set the distance, the sound cuts off for a moment.
• If each of the front or rear speakers are not placed an equal
distance from vour listening position, set the distance ot the
closest speaker.
• LX) not place the lear speaker farther awa\ from \'our listening
pi)sitii.)n than the fix)nt speakers.
■ BALANCE
You can vary the balance of each speaker as follows.
Default adjustments are in the parentheses.
• FRONT (tIdB)
Adjust the balance between the front left and right
spieakers (-6dB [L] to +6dB [R], 0.5dB steps).
• REAR(OdB)
Adjust the balance between the rear left and right
speakers (-6dB [L] to +6dB [R], 0.5dB steps).
Note
When \’ou .select "VES A" or "VES B" in "VIRTUAL 3D
SURROUND" in the Control Menu display, you cannot adjust
the le\ el or the balance of the speakers except for the front
speakers.
■ LEVEL
You can vary the level of each speaker as follows. Default
adjustments are in the parentheses.
• CENTER (OdB)
Adjust the level of the center speaker (-6dB to +6dB,
0.5dB steps).
• REAR (OdB)
Adjust the level of the rear speakers (-6dB to +6dB,
O.SdB steps).
• SUBWOOFER (OdB)
Adjust the level of fhe subwoofer (-lOdB to +6dB, O.SdB
steps).
■ TEST TONE
You can hear the test tone from each speaker in sequence.
• OFF: The test tone is not emitted from speakers.
• ON: During adjustment of "BALANCE" or "LEVEL,"
the test tone is emitted from both speakers
simultaneously.
Note
While you are playing a disc, you cannot hear the test tone.
Execute the test tone after you stop plat-back.
To adjust the volume of all the speakers at one
time
Use the receiver's (amplifier's) volume control.
To return to the default setting
Select the item, then press CLHAR.
60