Cisco 3030 - Manual (Page 22)

1-2
Cisco Catalyst Blade Switch 3030 Hardware Installation Guide
OL-8389-01
Chapter 1 Product Overview
Front Panel Description
Front Panel Description
Ten of the ports on the 16-port Gigabit Ethernet switch are internal 1000BASE-X ports that connect to
the server chassis through the backplane.
Figure 1-1 shows the console port, the two external
10/100/1000BASE-T copper ports, and the four external SFP module uplink ports that support
1000BASE-SX and 10/100/1000BASE-T copper. Only Cisco SFP modules are supported on the switch.
Figure 1-1 The Cisco Gigabit Ethernet Switch Module
Each port has an LED associated with it. The Dell Remote Access Controller/Modular Chassis
(DRAC/MC) management board controls the System Status/ID LED.
Switch Console Port
You can connect the switch to a PC by means of the console port and an RJ-45-to-DB-9 female cable. If
you want to connect the switch console port to a terminal, you need to provide an RJ-45-to-DB-25 female
DTE adapter. You can order a kit (part number ACS-DSBUASYN=) containing that adapter from Cisco.
For console port and adapter pinout information, see the
“Connector and Cable Specifications” section
on page B-1 .
For information on the server chassis DRAC/MC console port, see the server chassis documentation.
1 Switch module 6 Gigabit Ethernet port LEDs
2 Console port 7 SFP module ports
3 Console port LED 8 SFP module port LEDs
4 System Status/ID LED 9 Release latch
5 External Gigabit Ethernet ports
143470
11x
12x
13x
14x
15x
16x
Console
11x
12x
13x
14x
15x
16x
CON
2
3
5
9
4
8
7
6
1