Cisco 3030 - Manual (Page 34)

2-6
Cisco Catalyst Blade Switch 3030 Hardware Installation Guide
OL-8389-01
Chapter 2 Switch Installation
Installing the Switch Module into the Server Chassis
Installing the Switch Module into the Server Chassis
For a description of the switch module, see the “Features” section on page 1-1 .
Follow these steps to install the switch module into the server chassis:
Step 1 Obtain and make note of this information from your network administrator before you begin the switch
module installation:
• Switch IP address
• Subnet mask (IP netmask)
• Default gateway (router)
• Enable secret password (encrypted)
• Enable password (not encrypted)
• Telnet password
• SNMP community strings (optional)
Step 2 Select a chassis I/O module bay in which to install the switch module. Follow the prerequisites listed in
the
“Dell Modular Server Chassis Architecture” section on page 2-5 .
Step 3 Remove the end-cap (blank plug) from the selected bay. Store the end-cap (blank plug) for future use.
Step 4 If you have not already done so, touch the static-protective package that contains the switch module to
an unpainted metal part of the server chassis for at least 2 seconds.
Step 5 Remove the switch module from its static-protective package.
Step 6 Ensure that the release latch on the switch module is in the open position (perpendicular to the module).
(See
Figure 2-2 .)
Figure 2-2 Switch Module Release Latch in the Open Position
Step 7 Slide the switch module into the appropriate bay until it stops.
143473
11x 12x
13x
14x 15x 16x
Console
11x
12x
13x 14x 15x
16x
CON