Installing and removing sfp modules – Cisco 3030 User Manual

Page 41

Advertising
background image

2-13

Cisco Catalyst Blade Switch 3030 Hardware Installation Guide

OL-8389-01

Chapter 2 Switch Installation

Installing and Removing SFP Modules

interface Vlan1

no shutdown

ip address 10.0.0.1 255.255.255.0

!

interface GigabitEthernet0/1

!

interface GigabitEthernet0/2

. . . (output truncated)

interface GigabitEthernet0/16

!

end

Step 10

These choices appear:

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

If you want to save the configuration and use it the next time the switch reboots, save it

in NVRAM by selecting option 2.

Enter your selection [2]:2

Make your selection, and press Return.

Step 11

Disconnect the server chassis serial port or the switch console port from the PC. See the

“Management

Options” section on page 1-6

for information about managing the switch.

If you need to rerun the initial configuration dialog, see the

“Configuring the Switch Module” section

on page 2-7

.

To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal
program or through the network by using Telnet. For configuration information, refer to the switch
software configuration guide or the switch command reference.

Installing and Removing SFP Modules

These sections describe how to install and remove SFP modules. The modules are inserted into the
SFP module slots on the front of the switch module. These field-replaceable modules provide uplink
interfaces.

You can use any combination of SFP modules. Refer to the switch module release notes for the list of
SFP modules that the switch supports. Each port must match the wave-length specifications on the other
end of the cable, and the cable must not exceed the stipulated cable length for reliable communications.
See the

“Installation Guidelines” section on page 2-3

for cable stipulations for SFP connections.

Use only Cisco SFP modules on the switch. Each SFP module has an internal serial EEPROM that is
encoded with security information. This encoding provides a way for Cisco to identify and validate that
the SFP module meets the requirements for the switch.

For detailed instructions on installing, removing, and cabling the SFP module, refer to your SFP module
documentation.

Advertising