Bi-admin management – Cisco PSUS4 User Manual

Page 14

Advertising
background image

Chapter 4

Bi-Admin Management

11

PrintServer for USB with 4-Port Switch

Device Information

To choose a different device that you configured, click
Open. You may then browse for your file, select it, then
click Open. The contents of the file will display on the right-
hand side of the screen. To save the file to the PrintServer,
click Restore to Device.

Printer Status

This option allows you to view the printer

status, and set port and printer parameters.

If you click this option, a Verify Password screen will appear.
Make sure that you enter the password in the field before
you click OK. If an Incorrect Password message appears,
click OK, enter the correct password, and click OK again.

Verify Password

After the password is successfully entered, the Printer

Status screen will appear. The Device Name will be
displayed and USB Printer Port will be highlighted. The
status information for the port will be displayed.

Click Back to return to the Bi-Admin Management Utility
screen. Click Refresh to refresh the screen.

Printer Status

If the printer is Bi-directional, and is not busy, the Printer
Configuration
button will appear, as shown above. If the
items are not read only, you can change the Environmental
Variable and Variable Value items based on the options of
your printer.

For more information, click Help.

Configuration

You may configure the PrintServer with

this option. If you click this option, a Verify Password screen
appears. Enter the password in the field and then click OK.
If an Incorrect Password message appears, click OK, enter
the correct password in the field, and click OK again.

Verify Password

After the password is successfully entered, the

Configuration screen will appear.

The Configuration screen contains six tabs. System TCP/

IP, AppleTalk, NetBEUI, Internet Printing, and Port. Each tab
contains a different category of configuration setings. For
a detailed description of these tabs refer to section “Main
> Configuration Screen Tabs”.

Upgrade

This option is used to upgrade the firmware of

the PrintServer. Follow these instructions to upgrade your
PrintServer’s firmware:

Download the firmware to your computer from the

1.

Linksys website at www.linksys.com.
Open the Bi-Admin Management utility.

2.

Click

3.

Main, and then click Upgrade Firmware.

Click

4.

Files... to browse for the file on your computer.

Click

5.

Upgrade to upgrade the firmware.

Upgrade Firmware

Refresh

This option allows you to refresh the device list

after you change the name or IP Address of a device. The
screen does not refresh automatically.

Exit

This option allows you to exit the program.

Advertising